Troubleshooting - Sensear SM1P-Ex Manual

1. If Bluetooth® is not pairing to your device, first check to see if
Short-Range is turned on. You must first turn it off to use the MFB
for Bluetooth® pairing (see Short-Range section). After the
headset is in Bluetooth® pairing mode, Short-Range can be turned
back on.
2. If the two-way radio audio is not clear or distorted, or the headset
cuts out:
Adjust the two-way radio volume at the two-way radio
•
controls. Setting a volume level of 50% is a good starting
point.
Check that the battery in the two-way radio is charged.
•
3. If you cannot hear any of the surrounding environment:
• The headset may be in 'Quiet mode,' or power is not
present to the headset. Press the power button on the
headset to toggle between Quiet mode and
4. If the receiver cannot hear your voice and you can only hear the
background noise:
Refer to the 'Wearing the headset' chapter of the manual.
•
Ensure that your boom microphone is set up appropriately.

TROUBLESHOOTING

IECEx126 SM1P Ex Manual rev 10.00
28
mode