Table of Contents
Advertisement
RE-ASSIGNING DEVICE KEYS (continued)
To re-assign other device keys to the AUX key, repeat steps 1 through
6 on the previous page but substitute the key sequence from the
below chart:
To Re-Assign Device Key
AUX as 2nd TV key:
AUX as 2nd DVD key:
AUX as 2nd SAT key:
AUX as 2nd CD key:
AUX as 2nd CBL key:
AUX as 2nd RCVR/AMP key:
*NOTE: Press and hold SET (see step 1 on previous page).
You can also re-assign another unused device key by substituting an
open key for the AUX key in the above chart and performing the
sequence. For example, to re-assign an unused SAT key as a second
CD key, perform SET*-
USING KEYMOVER
The URC-9910 remote control includes a Keymover feature that
allows you to map (or copy) keys from one mode (i.e., source mode)
to another mode (i.e., destination mode).
NOTE: The following keys cannot be used as a source or destination: TV , VCR ,
DVD , AUX , SAT , CBL , RCVR/AMP , CD , HOME THEATER , and SET .
Programming Keymover
For example, if your VCR does not have volume control, try mapping
the volume and mute keys from TV mode to VCR mode as follows:
1.
2.
(x 8)
(x 7) - SELECT - CD - SAT.
On the URC-9910 remote control, press and hold
SET until you see the display change from the cur-
rent device and time to [CODE SET].
NOTE: The device, its code, and time are examples. Your
remote control settings may be different.
NOTE: To exit programming at any time, press EXIT once or
allow 30 seconds of inactivity to lapse. You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE: [INVALID] means you have inadvertently pressed an
incorrect key. Note your error and continue programming.
Press the
key eight times until you see the display
change to [KEYMOVER].
Perform Sequence
SET*-
(x 7) - SELECT - TV - AUX
SET*-
(x 7) - SELECT - DVD- AUX
SET*-
(x 7) - SELECT - SAT- AUX
SET*-
(x 7) - SELECT - CD- AUX
SET*-
(x 7) - SELECT - CBL - AUX
SET*-
(x 7) - SELECT - RCVR/AMP - AUX
38
Hide quick links:
Advertisement
Table of Contents
