Using Keymover; Programming Keymover; Restoring Keymoved Keys To Default Settings; Restoring A Single Keymoved Key - One for All 6-Device PVR Universal Remote Control User Manual

USING KEYMOVER

The One For All 6-Device PVR Universal
Remote Control (URC-6131n) includes
map (or copy) keys from one mode (i.e.,
source mode) to another mode (i.e.,
destination mode).
NOTE:
as a source or destination: TV, PVR, DVD,
CBL/SAT, AUD, VCR, and SET.

PROGRAMMING KEYMOVER

For example, if your VCR does not have
volume control, you can map those keys
(i.e., VOL +, VOL -, and MUTE) from the
TV mode to the VCR mode as follows:
1. Press and hold SET
light) blinks twice, then release SET.
9 9 4
3. For the source mode, press TV once.
4. For the source key, press VOL + once.
5. For the destination mode, press VCR
once.
6. For the destination key, press VOL +
once.
the keymoved sequence is correct.
to map remaining volume control
keys, substituting VOL - and MUTE as
source and destination keys in steps 4
and 6.
Upon completion of the above
procedure, you can now use your One
For All 6-Device PVR Universal Remote
Control (URC6131n) to control the TV's
volume and MUTE in the VCR mode, as
well as in the TV mode.
Owner's Manual
RESTORING KEYMOVED KEYS TO DEFAULT
SETTINGS

Restoring a Single Keymoved Key

1. Press a device key that has a
keymoved key.
2. Press and hold SET
light) blinks twice, then release SET.
9 9 4
4. Press the destination key twice (where
will blink twice.
Restoring All Keymoved Keys in a Single
Mode
1. Press and hold SET
light) blinks twice, then release SET.
9 9 4
3. Press the destination mode twice
(where keymoved keys are stored).

RE-ASSIGNING DEVICE KEYS

PVR Universal Remote Control
(URC-6131n) to control a second TV,
PVR/DVR, VCR, DVD player, or other
device. For example, to control a TV,
a cable box, and two VCRs, you will
need to re-assign the unused DVD key to
operate the second VCR as follows:
1. On the remote control, press and hold
SET
twice, then release SET.
9 9 2
3. Press VCR once, then press DVD once.
4. The DVD key is now ready to be
programmed for your second VCR.
on page 6.
To re-assign other device keys to the
DVD key, repeat steps 1 through 4 with a
sequence from the following chart:
9