One for All URC-9910 User Manual page 17

USING LEARNING
Programming A Learning Key (continued)
4.
5.
6.
7.
8.
9.
10.
Press a device key once (e.g., TV) to assign a desired
mode for learning.
Select an open learning key (e.g., L1) and press it
once.You will see the display change to [LEARNING]
and the LED (red light) will turn on for 5 seconds.
Place your original remote control (e.g., TV remote
control) head-to-head (about 2" apart) from the
URC-9910 remote control.
On your original remote control, press and hold the
key (i.e., feature) to be learned until you see [SUC-
CESS] appear on the URC-9910 remote control. The
display will return to device mode you selected for
learning (e.g., TV).
If the key was not learned, you will see an [ERROR]
message instead.
Repeat steps 5 through 7 as needed to achieve
[SUCCESS].
To learn functions onto other learning keys (e.g., L2
~ L4), repeat steps 4 through 7 for each key.
Press EXIT to exit the programming mode.You will
see an [EXIT SETUP] message as the remote control
returns to normal operation.
To test a learned feature, aim the URC-9910 remote
control at the desired device and press its device key
once (e.g., TV, where the learning mode was
assigned). Then press the learning key (e.g., L1)
2"
30