Optimizing Ir/Rf Command Center Reception; Specifications - One for All URC-9910 User Manual

USING THE RF/IR COMMAND CENTER
(continued)

Optimizing IR/RF Command Center Reception

Here are some adjustment tips for optimizing the operation of your
IR/RF Command Center:
• Aim the URC-9910 remote control toward the room where the
IR/RF Command Center is located.
• Do not position the IR/RF Command Center near metal objects,
such as heat ducts. Metal can absorb RF signals.
• Make sure the batteries in the URC-9910 remote control are fully
charged. Try replacing them if you are not sure (see Installing
Batteries on page 4).Weak batteries will affect the single range.
• Make sure that the URC-9910 remote control is not being affected
by other RF transmissions (e.g., garage door openers, cordless
telephones, etc.).
NOTE: The tests for range limits of the URC-9910 remote control and the
IR/RF Command Center were conducted in open-air distance tests. Actual
signal distance will be based on the construction of the building the unit is
being used in, as well as other factors, such as outside interference.

SPECIFICATIONS

Remote Control Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 AAA Batteries
IR/RF Console Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 Vac
Remote Control to IR/RF Console Range . . . . . . . . . . . . up to 100 Feet (30.48 m)*
IR/RF Command Console to Device Range . . . . . . . . . . . . . 25 Feet (7.62 m) ± 30˚
Remote Control Dimensions
(H x W x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-2⁄16 x 2-10⁄16 x 2-3⁄16 in.
(H x W x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 232 x 65 x 31 mm
IR/RF Command Console Dimensions
(H x W x D). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-9⁄16 x 5 -1⁄16 x 4 in
(H x W x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39.7 x 128.6 x 101.6 mm
Remote Control Weight (without Batteries) . . . . . . . . . . . . . . . . . . . . . . . 8 oz (220 g)
IR/RF Command Console Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10.4 oz (300 g)
NOTE: Specifications are typical. Individual units might vary. Specifications
are subject to change and improvement without notice.
*Distance may vary
54