Metro DataVac 9 Series Instructions For Use Manual page 17

Controlled humidity heated holding & proofing cabinets
Table of Contents

Advertisement

5. An element symbol below each digital display indicates when the temperature or humidity heater element
is energized. As the control settings are adjusted, it may take a few moments for the status of the indicator lights
to reflect the new control settings and cabinet conditions depending on when in the control cycle the settings are
changed.
6. If humidity is required, fill the water reservoir in the bottom of the cabinet to about
the water reservoir cover. Potable (suitable for drinking) water should be used. Water can be poured through the
rectangular hole in the water reservoir cover. If the cover is removed, replace it before using the cabinet. A water
sensor detects a low water condition and will prevent the water reservoir element from being energized. The reservoir
needs refilling when there is about 1" (25mm) of water left in the reservoir. At this point, the display will blink and
an audible alarm will sound, and the water reservoir element will not heat until the water reservoir is filled. If
humidity is not required, empty the water reservoir and Set humidity control and the display reads "Off."
7. To remove the water from the water reservoir, allow the water to cool, open the drain valve under the right end of the
drip trough and allow the water to drain. Any remaining water in the bottom of the reservoir can be removed with a
clean towel.
Note: When turning the cabinet off at the end of the work day, it is recommended to leave the door(s) open to prevent
heat and condensation build up within the cabinet.
Note: If the cabinet is not going to be used for an extended period of time, all water should be removed from the water
reservoir and the cabinet completely cleaned and dried out.
8. Click on "HELP TRAINING" detailed instructions on controller features please go to help section and scan OR code or
go to URL to view detailed videos.
C5 9 Series Cabinets — INSTRUCTIONS FOR USE
Water Reservoir
Fill with water to one half inch
below the water reservoir cover.
Water Reservoir Drain Valve
17
www.metro.com
/
" (13mm) below the bottom of
1
2
L01-419
REV S 11/22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 9 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents