Table of Contents
Advertisement
Quick Links
INSTRUCTIONS FOR USE
T-SERIES HOT FOOD HOLDING CABINETS
DESCRIPTION
THIS MANUAL COVERS CABINETS WITH ELECTRICAL RATINGS OF: 120V 1400W &
220-240V 1176-1400W
When ordering electrical parts, always confirm the rating
listed on cabinet data plate on back of cabinet.
Differences in voltage, amps or wattage are listed with
BOLD TEXT in replacement part descriptions.
Advertisement
Table of Contents
Related Manuals for Metro DataVac T Series
Summary of Contents for Metro DataVac T Series
- Page 1 INSTRUCTIONS FOR USE T-SERIES HOT FOOD HOLDING CABINETS When ordering electrical parts, always confirm the rating listed on cabinet data plate on back of cabinet. Differences in voltage, amps or wattage are listed with BOLD TEXT in replacement part descriptions. DESCRIPTION THIS MANUAL COVERS CABINETS WITH ELECTRICAL RATINGS OF: 120V 1400W &...
-
Page 2: Table Of Contents
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE TABLE OF CONTENTS SAFETY INFORMATION ..............................2 SAFETY SYMBOLS ................................2 IDENTIFY YOUR CABINET ..............................2 PRODUCT FEATURES ............................... 3 INSTALLATION AND SETUP .............................. 5 OPERATING INSTRUCTIONS (DIGITAL CONTROLLER) ....................8 OPERATING INSTRUCTIONS (ANALOG CONTROLLER) .................... -
Page 3: Product Features
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE PART NUMBERING - D S B C5 T 9 D _ _ _ A _ __ _ _ _ ACCESSORIES CABINET NAME SLIDES L = ADJUSTABLE LIP LOAD 18x26 & 12x20 T = T-SERIES B = ADJUSTABLE BOTTOM LOAD 18x26 &... - Page 4 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Digital Controller (Single Cavity Cabinets) Power Selection HEAT OFF HI Temperature ELEMENT Switch Switch Indicator Alarm Indicator Indicator Settings/Enter Temperature Temperature PREHEAT Battery Charge LO Temperature Switch Range Display Indicator Indicator Alarm Indicator Analog Controller (Single Cavity Cabinet) Temperature Range...
-
Page 5: Installation And Setup
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE INSTALLATION AND SETUP NOTE: The First 4 steps below are common to both Analog and Digital cabinets. 1. Check for Shipping Damage: Check the packaging and cabinet for shipping damage before and after unloading the unit, and after removing all packaging materials. - Page 6 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Maximum Capacity of Adjustable Slides (Lip and Bottom Loads) NOTE: Only lip load capacities are shown below. Bottom loads have the same capacities. SiteSelect™ feature make slide installation easier. 1/2 HEIGHT CABINET FULL HEIGHT SINGLE 5/6 HEIGHT CABINET DUAL CAVITY...
- Page 7 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Fixed Lip Load Slide Configurations DUAL CAVITY FULL HEIGHT 1/2 HEIGHT 5/6 HEIGHT 1-Piece Construction 1-Piece Construction 1-Piece Construction (2 Pairs) 1-Piece Construction Part No. C5T-9DCFXSLIDE Part No. C5T-9FXSLIDE Part No. C5T-5FXSLIDE Part No.
-
Page 8: Operating Instructions (Digital Controller)
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE OPERATING INSTRUCTIONS (DIGITAL CONTROLLER) NOTE: Before using your cabinet for the first time, heat the cabinet to maximum temperature for 15 minutes to burn off oils on stainless from manufacturing process. During this process slight smoke may be seen. Power-Up and Pre-Heat •... - Page 9 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE • The cabinet will charge any time, when the power cord is plugged-in. Low Temperature Alarm Checking the low temperature alarm set point • Press and hold the “Settings” button, followed by the “-” button, then release both. The display shows the current low temperature alarm set point and illuminates the LO TEMP led (blinking) for 5 seconds, before again showing the current cabinet temperature.
- Page 10 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE NOTE: Audio (if enabled), Button press produces a 1/4 second “chirp”. Low temp Alarm: (3) 1/2 second beeps, repeating every 10 seconds. Controller User Settings • User settings are classified as: 1.
-
Page 11: Operating Instructions (Analog Controller)
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE OPERATING INSTRUCTIONS (ANALOG CONTROLLER) • Analog cabinets are controlled by an ON/OFF power switch and adjustable thermostat(s). • Indicator light near power switch glows when cabinet is turned on. • Indicator light(s) near thermostat(s) glow when the cabinet heat element(s) are on to achieve or maintain cabinet temperature. -
Page 12: Handling Instructions For Transporting Cabinet
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE HANDLING INSTRUCTIONS FOR TRANSPORTING CABINETS • Always assure brakes are set in OFF position prior to moving cabinet. • Assure door(s) is fully closed and travel latch (if equiped) is engaged. •... -
Page 13: Basic Troubleshooting
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE BASIC TROUBLESHOOTING WARNING: Only factory approved service agents should attempt to service, repair or replace electrical components, wiring or power cord. 1. Controls do not work (no display or indicator lights): •... -
Page 14: Service And Replacement Parts
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE SERVICE AND REPLACEMENT PARTS WARNING: Only factory approved service agents should attempt to service, repair or replace electrical components, wiring or power cord. Cabinet, Door and Electrical Parts Replacement Replacement ITEM # Part No. - Page 15 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Some components are common to all cabinets. Certain items are common to both the single NOTE: and dual cavity cabinets. Some electrical components are only used on dual cavity units. Refer to replacement parts list on page 14 and read the descriptions carefully to insure desired replacement part is ordered.
- Page 16 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE REMOVABLE REMOVABLE ACCESS COVER TOP COVER CONTROL MOTOR THERMOSTAT INSULATION PANEL MOUNTING BRACKET BRACKET ANALOG SINGLE CAVITY CABINET ALL CABINETS EXCEPT 1/2 HT MODELS SINGLE AND DUAL CAVITY CABINETS USE DIFFERENT ELECTRIC COMPONENTS.
- Page 17 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Several components of digital cabinets are common with analog cabinets. Refer to NOTE: replacement parts list on page 14 for details. DIGITAL CONTROL PANEL 51 50 (SEE BELOW IMAGE) REMOVABLE COVER 1 - SGL CAVITY 2 - DUAL CAVITY 1 - SGL CAVITY...
-
Page 18: Service And Replacement Parts (Circuits)
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE SERVICE AND REPLACEMENT PARTS (CIRCUITS) Analog Dual Cavity Cabinet POWER CORD AC BLOWER MOTOR STRAIN RELIEF GROUND STUD AIR ELEMENT TOP COMPARTMENT GREEN THERMAL CUT OUT WIRE NUT WIRE NUT AC BLOWER MOTOR AIR ELEMENT BOTTOM COMPARTMENT THERMAL... - Page 19 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Digital Dual Cavity Cabinet 50 51 L01-459 REV N 02/21 www.metro.com...
- Page 20 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Analog Single Cavity Cabinet POWER CORD STRAIN RELIEF GROUND STUD AC BLOWER MOTOR GREEN AIR ELEMENT THERMAL CUT OUT TERMINAL BLOCK 14 8 16 10 17 11 THERMOSTAT THERMOMETER BULB BULB BLACK 16"...
- Page 21 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE Digital Single Cavity Cabinet 50 51 L01-459 REV N 02/21 www.metro.com...
-
Page 22: Warranty
T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE ® 02/2021 For online warranty registration, please go to www.metro.com/service-support/thermal-cabinets to register electronically L01-459 REV N 02/21 www.metro.com... - Page 23 T-SERIES HOT FOOD HOLDING CABINETS — INSTRUCTIONS FOR USE THIS PAGE IS KEPT INTENTIONALLY BLANK L01-459 REV N 02/21 www.metro.com...
- Page 24 © 2021 InterMetro Industries Corporation, Wilkes-Barre, PA 18705 L01-459 REV N 02/21...
Need help?
Do you have a question about the T Series and is the answer not in the manual?
Questions and answers