Changing The Ils Cdi Scale; Setting The Arrival Alarm And Alarm Distance - Garmin GNS 530 Pilot's Manual & Reference

Changing the ILS CDI scale:

1) Select 'CDI/Alarms' from the Setup Page, using
the steps described at the beginning of this
section.
2) Turn the large right knob to highlight the 'ILS
CDI Capture' field.
Turn the small right knob to select 'Auto' or
3)
'Manual' as desired (Figure 10-34). Press the
ENT Key to accept the selection.
Figure 10-34 ILS CDI Window
190-00181-00 Rev. H
Setting the arrival alarm and alarm
distance:
1)
2)
3)
4)
GNS 530(A) Pilot's Guide and Reference
Select 'CDI/Alarms' from the Setup Page, using
the steps described at the beginning of this
section.
Turn the large right knob to highlight the
'On'/'Off' field (directly below 'Arrival Alarm').
Turn the small right knob to select 'On' or
'Off', as desired. Press the ENT Key to accept
the selection.
The flashing cursor moves to the alarm distance
field (to the immediate right of 'On' or 'Off').
To enter an arrival alarm distance, use the small
and large right knobs to enter the desired
alarm distance. Press the ENT Key when
finished.
NOTE: The CDI scale is always measured in
nautical miles, regardless of the current distance
units of measure selected on the Units/Position
Page.
SECTION 10
AUX PAGES
10-23