Garmin GNS 530 Pilot's Manual & Reference page 180

SECTION 10
AUX PAGES
CDI Scale/Flight Phase:
Auto (oceanic)
5.0 nm or Auto (enroute)
±
1.0 nm or Auto (terminal)
±
0.3 nm or Auto (approach)
±
Table 10-2 CDI Scales
An 'auto' ILS CDI selection allows the GNS 530
to automatically switch the external CDI from
the GPS receiver to the VLOC receiver, when
established on the final approach course (Section
6.3). Or, select 'manual' to manually switch the
external CDI connection, as needed.
An arrival alarm, provided on the CDI/Alarms
Page, may be set to notify the pilot with a message
when the aircraft has reached a user-defined
distance to the final destination (the direct-to
waypoint or the last waypoint in a flight plan).
Once the aircraft has reached the set distance (up
to 99.9 units), an 'Arrival at [waypoint]' message
is displayed.
The Airspace Alarms fields allow the pilot to
turn the controlled/special-use airspace message
alerts on or off. This does not affect the alerts
listed on the Nearest Airspace Page or the
airspace boundaries depicted on the Map Page. It
simply turns on/off the warning provided when
approaching or near an airspace.
An altitude buffer is also provided which 'expands'
the vertical range above or below an airspace. For
example, if the buffer is set at 500 feet, and the aircraft
is more than 500 feet above or below an airspace,
the pilot is not notified with an alert message; if
the aircraft is less than 500 feet above or below an
airspace and projected to enter it, the pilot is notified
with an alert message. The default is 200 feet.
10-20
RAIM Protection:
4.0 nm
2.0 nm
1.0 nm
0.3 nm
GNS 530(A) Pilot's Guide and Reference
• 'Units/Position' - Allows the pilot to configure
the displayed data to standard or metric units of
measure. This setting applies to distance, speed,
altitude, fuel, pressure, and temperature. Also
provides three magnetic variation (heading)
options: True, Auto, or User-defined. If 'Auto' is
selected, all track, course and heading information
is corrected to the magnetic variation computed
by the GPS receiver. The 'True' setting references
all information to true north, and the 'User' setting
corrects information to an user-entered value.
Configuration settings for position format are
also provided, and the map datum setting is
shown. The map datum used in the GNS 530
is WGS 84. Note that a map datum that does
not match the charts can result in significant
differences in position information. When using
the paper charts for reference only, the GNS 530
still provides correct navigation guidance to the
waypoints contained in the database, regardless of
the datum differences.
• 'Date/Time' - Provides settings for time format
(local or UTC; 12- or 24-hour) and time offset.
The time offset is used to define current local
time. UTC (also called GMT or Zulu) date
and time are calculated directly from the GPS
satellites' signals and cannot be changed. To use
local time, simply designate the offset by adding
or subtracting the correct number of hours.
190-00181-00 Rev. H