Garmin GNS 530 Pilot's Manual & Reference page 87

The steps required to set up and fly the approach
are detailed below (refer to Figure 6-8 for the following
steps):
1) Prior to departing KFDK, the destination (KLYH)
is selected using the Direct-to Key or by
creating a flight plan terminating at Lynchburg
Regional.
2) While enroute to KLYH, select the ATIS
frequency from the list on the NAV/COM Page
(Section 3.6 and Figure 6-9) and place it in
the standby field of the COM Window. Use
the COM Flip-flop Key to make the ATIS
frequency active.
Figure 6-9 NAV/COM Page
3) Press the PROC Key (Figure 6-10) and
select the 'VOR 04' approach using
t h e s t e p s o u t l i n e d i n S e c t i o n 6 . 1 .
190-00181-00 Rev. H
4)
5)
GNS 530(A) Pilot's Guide and Reference
Figure 6-10 Procedures Page
From the Transitions Window (Figure 6-11),
select LYH VOR (the IAF). Also, select 'Load?'
to load, but not activate, the approach.
Figure 6-11 Approach and Transitions Windows
Press the PROC Key, select 'Activate Approach?'
and press the ENT Key to activate the
approach.
SECTION 6
PROCEDURES
6-5