Scsi Bus Address; Cd Rom Configuration Jumper Locations - HP 9000 300 Series Service Handbook

Figure 3-5 shows you the configuration jumper locations. Jumpers and their
settings are explained in Table 3-11. Note the jumper positions that represent
an 'out' and 'in.'
Figure 3-5. CD ROM Configuration Jumper Locations
Table 3-11. CD ROM Drive Configuration Jumper Functions
Jumper
Label Function
ID1,ID2,ID4 SCSI ID Address; Jumper IDl is least
significant bit. Shipped with address 2 set
I
(default); jumper only on ID2
PRTY Parity checking; Out = Disabled, In
=
Enabled.
PRV/ALW Media removal; Out = eject button enabled, In
1
= eject button ignored.
TEST Test; for factory use only.
TERM Termination power source; In
=
from drive, Out
=from bus
SCSI Bus Address
Your CD ROM drive's SCSI ID jumpers must he set to the bus address it will
use. Your CD ROM has bus address 2 factory set. Set your CD ROM's SCSI
Configurations 3-23