Dhcp - Compaq iPAQ CP-2E User Manual

Advanced Setup Icons
4. For user-defined protocols, select the Service Type (TCP or UDP) to
block. This will not block all TCP or UDP traffic, just that traffic of
the matching protocol type or port number.
5. Click Apply. The Connection Point CP-2E must be rebooted for
applied changes to take effect.
6. Click OK. You can reboot the Connection Point CP-2E at any time by
clicking the Reboot button at the left.

DHCP

The Connection Point CP-2E has an integrated DHCP server that allows
you to automatically configure TCP/IP settings on computers attached to
the local network. The DHCP server can provide the following settings to
PCs on the local network:
> IP address
> Subnet mask
> Default gateway (which is the LAN interface IP address of
the Connection Point CP-2E)
> DNS server
DHCP: Displays the status (enabled or disabled) of the integrated
DHCP server. If you disable the integrated DHCP server, you must
configure the TCP/IP networking settings on each of your PCs
manually.
DHCP Start Address: Displays the first IP address to be leased out
by the DHCP server. The default is 192.168.1.11.
DHCP End Address: Displays the last address to be leased out by
the DHCP server. The default is 192.168.1.254.
5–14 iPAQ Connection Point CP-2E User Guide