Powering Up; Client Pc Configuration - Compaq iPAQ CP-2E User Manual

1. Plug one end of the supplied Ethernet cable into the port labeled 1 on
the back of the Connection Point CP-2E.
2. Plug the other end of the Ethernet cable into the Ethernet port on the
2
PC.

Powering Up

1. Plug the power adapter into an AC power outlet.
2. Connect the output of the power adapter to the 12V DC power input
on the rear of the Connection Point CP-2E.
The Power LED on the front panel should light up immediately.
The Connection Point CP-2E runs a series of self-tests to verify that it is
operating properly. The Test LED on the front panel remains lit while the
self-tests are running. The Connection Point CP-2E is ready to use when
the Test LED turns off.

Client PC Configuration

The configuration procedure for Windows 98 and ME clients is described
below.
Note: The configuration procedure for Windows XP, 2000 and NT4.0 are
described in Chapter 3, Adding PCs to Your Network.
The Connection Point CP-2E automatically provides the following
TCP/IP configuration information to your PC:
iPAQ Connection Point CP-2E User Guide
Installation and Configuration
1
1
2
2–3