Going For A Run; Putting On The Heart Rate Monitor - Garmin Forerunner 910XT Quick Start Manual

Fitness equipment is active.
Run sport is active.
Bike sport is active.
Swim (open or pool) sport is
active.
Other sport is active.
Putting on the Heart rate
Monitor
nOTE: If you do not have a heart rate
monitor, you can skip this task.
nOTE: The Forerunner cannot record
heart rate data while swimming.
Wear the heart rate monitor directly on
your skin, just below your breastplate. It
should be snug enough to stay in place
during your run.
1
Connect the heart rate monitor module
to the strap.
➊
2
Wet both electrodes
back of the strap to create a strong
Forerunner 910XT Quick Start Manual
➊
on the
➋
connection between your chest and
the transmitter.
3
Wrap the strap around your chest, and
connect it.
The Garmin logo should be right-side
up.
4
Bring the device within range (3 m) of
the heart rate monitor.
TIP: If the heart rate data is erratic
or does not appear, you may have
to tighten the strap on your chest or
warm up for 5–10 minutes.
After you put on the heart rate monitor, it
is on standby and ready to send data.
When the heart rate monitor is paired, a
message appears, and
on the screen.

going for a run

Before you can record history, you must
locate satellite signals
your Forerunner with an optional foot pod.
1
Select STarT to start the timer
➋
appears solid
(page 3) or pair
➊
.
5