Page 1
Technical Reference 020-103050-04 MicroTiles LED Serial Commands...
Page 2
Christie's control such as maintenance of the product in proper working conditions. Performance specifications are based on information available at the time of printing. Christie makes no warranty of any kind with regard to this material, including, but not limited to, implied warranties of fitness for a particular purpose.
MicroTiles LED Understand the information and procedures for communicating with MicroTiles LED from a remote location. You can communicate with the MicroTiles LED wall controllers through RS232 or Ethernet. Using RS232 requires a USB to RS232 dongle. Connection and use...
ASCII code (A-Z, upper or lower case). This function code appears immediately after the leading parenthesis that starts the message. In messages sent to MicroTiles LED that do not have a subcode, a space between the function code and the first parameter (or special character) is optional.
(PWR!000). Data The value for a given MicroTiles LED state, such as on or off, appears in ASCII- decimal format directly after the request/reply symbol. You can add an optional space after the symbol—such as before the data—in a set message, but data in replies follow the exclamation mark (!) symbol without a space.
The acknowledgment is returned after the message has been received and fully executed by MicroTiles LED (such as in the case of a source switch it is not sent until the switch is complete). If the message cannot be executed for some reason (such as invalid parameters, time-out, and so on) a NAK is returned instead (not-acknowledge).
System busy - Try again later Product documentation For installation, setup, and user information, see the product documentation available on the Christie website. Read all instructions before using or servicing this product. 1. Access the documentation from the Christie website: •...
Serial API commands The MicroTiles LED commands can be used to modify product settings. BRI–Array Brightness Sets the brightness of the array, from 0 to 100% of the array capacity. Commands Command Description Values BRI <value> Changes the array brightness.
0. Examples Display the number of tiles in the currently powered on array: (TIL+CURR) TMD–Time and Date Sets the display time and date for all devices in the MicroTiles LED array. Commands Command Description Values TMD+DATE <date>...