LawnMaster CLGT2425S Instruction Manual page 22

MAINTENANCE
WARNING
Before replacing the spool line, make sure the battery is removed from the trimmer. The line cutting
blade, located on the safety guard is sharp. Take extra care and wear protective gloves.
the spool. Ensure the line is not held in the parking slot on the spool before replacing the spool
cover referring to the Line Replacement section.
in the corresponding recesses of the trimmer head. They lock in audibly.
CAUTION
least a minute to verify the line and the tool are both operating correctly. Use only the spool and
line as recommended by the manufacturer.
Line Replacement (See Fig. 25)
NOTE: Remove any old line remaining on the spool. Cut a length of line approximately 5 m long.
Wind the line onto the spool. Ensure the line is wound in the direction indicated by the arrows
on the spool.
NOTE: Always clean the spool cover and trimmer head housing before reassembling the trimmer
head. Always clean the trimmer head before replacing the spool.
NOTE:
22