Steering Wheel And Controls; Horn Button; Tilt/Telescope Lever; Multi-Function Turn Signal Switch - Komatsu 930E-4SE Operation & Maintenance Manual

Operator Cab And Controls - Section 32
Page 32-2

STEERING WHEEL AND CONTROLS

Steering wheel (1, Figure 32-2) can be telescoped
"in" and "out" and the lilt angle can be adjusted to
provide a comfortable steering wheel position for
most operators.

Horn Button

Actuate horn (2, Figure 32-2) by pushing the button
in the center of the steering wheel. Ensure that the
horn operates before moving the truck. Observe all
local safety rules regarding the use of the horn as a
warning signal device before starting the engine and
moving the vehicle.
Tilt / Telescope Lever
The steering column can be telescoped and the
steering wheel can be tilted with lever (3, Figure 32-
2) in front of the turn signal lever.
Adjust the tilt of the steering wheel by pulling the
lever toward the steering wheel and moving the
wheel to the desired angle. Releasing the lever will
lock the wheel in the desired location.
Adjust the steering column by pushing the lever
forward to unlock the telescoping function. After
positioning as desired, release the lever to lock the
steering column in position.
FIGURE 32-2. STEERING WHEEL & CONTROLS
1. Steering Wheel
2. Horn Button

3. Tilt/Telescope Lever

4. Multi-Function Turn
Signal Switch
5. Retarder Lever

Multi-Function Turn Signal Switch

Multi-function turn signal switch (4, Figure 32-2) is
used to activate the turn signal lights, the windshield
wipers, and to select either high or low beam
headlights.

Turn Signal Operation

Move the lever upward to signal a right turn.
An indicator in the top, center of the instrument
panel will illuminate to indicate turn direction
selected. Refer to Instrument Panel and Indicator
Lights in this section.
Move the lever downward to signal a left
turn.
NOTE: The turn signal does not automatically
cancel after the turn has been completed. The
turn signal lever must be manually returned to
the neutral position.

High Beam Headlight Operation

Pulling the lever inward (toward the rear
of the cab) changes the headlights to
high beam. When the high beams are
selected, the indicator in the top center of the
instrument panel will illuminate. Moving the
switch back to the original position will return the
headlights to low beam.

Windshield Wiper Operation

Windshield Wipers OFF
Intermittent - Long Delay
Intermittent -Medium Delay
Intermittent -Short Delay
Low Speed
High Speed
Depressing the button at the end of the lever
will activate the windshield washer.
NOTE: The wipers will not come on automatically
when activating the washer. This must be done
manually.
8/11 OM3245