Using The Radio; Finding A Station; Setting The Presets - Komatsu 930E-4SE Operation & Maintenance Manual

Radio / CD Player - Section 70
Page 70-4
After 5 seconds of inactivity, the receiver will return to
the default display and the volume level at which the
receiver was previously playing.
NOTE: The alarm will be activated unless the
ALARM button is held for 2 seconds again.

USING THE RADIO

Finding a Station

BAND (2): Press this button to switch between AM,
FM1, FM2, FM3, and Weather (WX). The receiver
display will show your selection.
+TUNE/SEEK- (6): Press and hold both +TUNE and
BAND (2) for 2 seconds to switch between manual
tune and seek modes. The display will show either
MANUAL or SEEK to indicate the mode.
MANUAL TUNE: Press the +TUNE/SEEK- (6) but-
ton once to tune to the next higher or lower station,
one frequency at a time. Holding +TUNE/SEEK- for
more than half a second begins fast tuning.
SEEK: Press the +TUNE/SEEK- (6) button once to
tune to the next higher or lower station. Holding
+TUNE/SEEK- for more than half a second activates
the Seek function, and SEEK will appear on the dis-
play. When a station with a strong enough signal is
found, Seek will stop and the station will play. If a sta-
tion is not found with a strong enough signal after
searching the band twice, the Seek function will end
and NO STATION FOUND will appear for 5 seconds.
Then, the default display will appear and the radio
will continue to play. Seek can be cancelled by press-
ing +TUNE/SEEK- again.
AUDIO STORE (AUTO): AUTO automatically stores
the 6 strongest stations onto pushbuttons 1-6. Press
and hold PSCN/AUTO (8) until AUTO and the AS
icon appear on the display. AUTO STORE only saves
presets in the band to which you are listening. If you
press AUTO while listening to FM1, the presets on
AM, FM2, FM3 and WX will not change. Pressing
and holding AUTO again for more than 2 seconds will
cancel Auto Store, and the original presets will be
restored.
SCAN: Press SCAN/DIM (9) to scan all stations on
the current band. When a frequency of sufficient
strength is found, the radio will play for 5 seconds
and then continue scanning until you press SCAN
again. The display will show SCAN and the fre-
quency being scanned.
PSCN: Press PSCN/AUTO (8) to scan the presets
on the band the radio is currently playing (FM will
scan FM1, FM2 and FM3). When a preset frequency
of sufficient strength is found, the radio will play for 5
seconds and then continue scanning. The display will
show PSCN, the frequency, preset number and the
band icon. Preset Scan will continue until the PSCN
is pressed again.

Setting the Presets

The six numbered pushbuttons allow to preset 6
favorite stations per band and easily return to them
with the touch of a button. To set the presets:
1. Turn the key switch and the receiver ON.
2. Select the band.
3. Tune to the desired station.
4. Press and hold one of the six numbered buttons
for more than 2 seconds to store the selected
station. During the 2-second set time, the radio
will be muted and the number icon will not be
visible. Both the audio and selected preset icon
will return, indicating the station has been set.
5. Repeat steps 1-4 for each push-button.
Pressing a preset button in the future will tune the
radio to the station you set on the band to which you
are listening.
03/10 OM7006