Table of Contents
Advertisement
OM1074 8/11
ABOUT THIS MANUAL
The front cover of this manual includes a form number. This form number should be referenced when ordering
additional copies of this manual or for any other correspondence regarding the coverage in this manual.
Direct all inquiries to:
Komatsu America Corp.
Datakom, Peoria Technical Publications
P.O. Box 240
Peoria, IL 61650-0240
(309)-672-7072 - FAX
This first section is an Introduction to the manual. It contains the Table of Contents for locating specific areas of
interest. Other sections include:
• Torque Tables & Conversion Charts
• Safety
• Warnings and Cautions
• Operating Instructions
• Operator Cab and Controls
• Lubrication and Service
• Automatic Lubrication System
• Components & Specifications
• Payload Meter III
• AM/FM Radio / CD/Player
When searching for a specific area of interest, go first to the Table of Contents to locate the section in which the
subject might generally be included. Then, find a subject description that most closely describes the specific area
of interest and go to that page. Section numbers and page numbers are located at the top, outside corner of the
page.
At the top, inside corner of the page is a document (module) number. If there is ever a question regarding the
information in a particular section, refer to the document (module) number, the manual form number, and use the
address shown above to correspond. If there is a date (month/year) behind the document (module) number, that
date indicates the latest revision date of that page.
The illustrations used in this manual are TYPICAL of the component shown and may not be an exact reproduction
of what is found on the truck.
This manual shows dimensioning of U.S. standard and metric (SI) units throughout. All references to "right," "left,"
"front," or "rear" are made with respect to the operator's normal seated position unless specifically stated otherwise.
When assembly instructions are provided without references to specific torque values, standard torque values
should be used. Standard torque values are shown in torque charts in the Standard Charts and Tables section in
this manual and in the General Information section of the truck shop manual. Specific torques, when provided in
the text, are in bold face type, such as 135 N•m (100 ft lb). All torque specifications have ±10% tolerance unless
otherwise specified.
Introduction - Section 10
Page 10-3
Advertisement
Table of Contents
Troubleshooting
