Using The Clock; Setting The Clock; Using The Alarm; Setting The Alarm - Komatsu 930E-4SE Operation & Maintenance Manual

OM7006 03/10
SEEK SENSITIVITY: To adjust seek sensitivity,
press the AUDIO knob until SEEK and the sensitivity
level appear. Rotate the AUDIO knob to the desired
setting. Increasing the sensitivity will help find more
stations, including slightly weaker ones, while
decreasing it will cause fewer, but stronger stations
to be found.
SPEAKERS: Press the AUDIO knob until SPKR 4
appears on the display; rotate the knob to switch to
2-speaker functionality. SPKR 2 will appear on the
display.
After 5 seconds of inactivity, the receiver will return to
the default display.

USING THE CLOCK

The clock can function in a 12 or 24-hour mode. The
12-hour mode distinguishes between AM and PM.
The 24-hour mode operates as military time. To tog-
gle between the two modes:
1. Turn the key switch ON.
2. Press and hold the TMSET/ DSPL button for 2
seconds until the digits flash. This indicates you
are in the time set mode.
3. Press and release push-button 5 to toggle
between 12-hour and 24-hour modes.
After 5 seconds of inactivity, the display will return to
the default display, and the current mode will be set.

Setting the Clock

1. Turn the key switch ON.
2. Press and hold the TMSET/DSPL button until
the hours digits flash.
3. Press the +TUNE/SEEK- (6) to set the correct
hour.
4. Press the TMSET/DSPL button again, and the
minutes digits will flash.
5. Press the +TUNE/SEEK- (6) button to set the
correct minute. Seconds are reset to zero when
the minutes setting is changed.
After 5 seconds of inactivity, the display will return to
the default display and the clock will be set.
Radio / CD Player - Section 70

USING THE ALARM

Momentarily pressing the ALARM (10) button will dis-
play the alarm set time.
When the ALARM icon is on the display, the alarm
has been set. If the radio is on when the alarm
sounds, there will be a beeping noise. If the receiver
is off, the alarm will turn on and play the radio at the
alarm volume. The alarm will continue to sound until
the snooze is activated or the alarm is turned off.

Setting the Alarm

1. Press and hold the ALARM (10) button for 2
seconds until the ALARM icon and the display
show AL TIME plus the current alarm time. This
indicates the alarm-setting mode.
2. Press and release the +TUNE/SEEK- (6) until
the desired alarm hour appears on the display.
3. Press the ALARM (10) button again to select
the minutes display.
4. Press the +TUNE/SEEK- (6) until the desired
alarm minutes appear on the display.
After 5 seconds of inactivity, the receiver will return to
the default display, and the ALARM icon will remain
illuminated indicating the alarm is set.

Turning the Alarm Off

Press and hold the ALARM (10) button until the dis-
play shows ALARM DISABLED and the ALARM icon
on the display disappears.

Activating Snooze

Press any button on the radio faceplate when the
alarm is sounding. The alarm will sound again in 9
minutes.

Setting Alarm Volume

1. Turn the receiver on.
2. Press and hold the ALARM button for 2 sec-
onds until the ALARM icon and the display
shows AL TIME plus the current alarm time.
Rotate the AUDIO knob to increase or decrease
the alarm volume as desired.
Page 70-3