Care And Handling Of Your Scuba Force Drysuit - Scuba Force EXPLORER NST Owner's Manual

DRY SUIT OWNER MANUAL

Care and handling of your SCUBA FORCE drysuit

Careful handling of your drysuit will increase ist life.
After finishing diving for the day, thoroughly rinse the ouotside of your SCUBA
FORCE drysuit with fresh water. Pay special attention to the zipper and valves.
Flush the air outlet valve and the air inlet valve with running water. Then blow the
valves dry with compressed air.
If the inside of your drysuit gets wet, rinse it out as well.
Wash the latex cuffs with a mild, soapy solution after every twelfth dive or before
storing the drysuit. Body fat buildup shortens the life of latex cuffs.
After rinsing the drysuit, open the zipper and hang the drysuit by the socks / shoes
over a clothesline or drying rack in a shaded place to dry.
When your drysuit is completely dry, apply talc on the latex cuffs. Close the zipper
and lubricate it with SCUBA FORCE WAX (metal) or silicone grease (plastic). Use a
toothbrush to periodically clean the zipper of the drysuit with soap and
water and to remove dirt and debris from the zipper before lubricating
it.
If you have any questions about the care and handling of your SCUBA
FORCE drysuit, please contact your SCUBA FORCE dealer.
Manual Version DS2019-1
NOTE
The valves of the drysuit, like your regulator, must be
cleaned after each use. Air intake valves can block due to
salt build-up in the valve. Air outlet valves can block due to
debris,dirt or hair in the valve.
CAUTION
Do not hang your drysuit in the sun.
Page 42 of 45