Pull Out Neck Cuffs; Silicone Cuffs And Change System - Scuba Force EXPLORER NST Owner's Manual

DRY SUIT OWNER MANUAL
Take off neck cuffs
Latex
• Grasp the upper opening of the neck cuff with both hands from the outside.
• Spread the latex neck cuff with both flat hands as far as you can (do not dig
your fingernails into the neck cuff).
• While spreading the neck cuff, lift both arms while pulling your head to your
chest. Pull your head out of the cuff and out of the dry suit.
• If you need help, have your diver place his / her hands in the zipper opening
under the air inlet valve. Lift the front of the suit until it is over your head. Do
not stretch the zipper.
Neopren
• Unroll the neck cuff so that it is not knocked over (nylon is attached to your
skin).
• Grasp the neck cuff with your hands on both sides of your head and pull it
up until the top edge is at chin height.
• Slide your fingers into the cuff as far as the edge and grasp them with
fingers and thumbs. Pull your chin to your chest and, while tilting your head
slightly, pull the cuff upwards.
Silikon cuffs and quick change systems
SCUBA FORCE only uses changing systems with silicone sleeves made by SiTech.
If you chose to buy a silicone change system when purchasing your SCUBA FORCE
drysuit, you will also receive a user guide from SiTech suitable for your chosen
system. Please read this manual carefully before using your new dry suit.
Manual Version DS2019-1 Page 23 of 45