Useful Information - Atlas Copco LBB16 EP024-U Instructions Manual

Pistol-grip drills

page of 180

/ 180
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

LBB16 EP024-U

This can be prevented by flushing with oil (a few drops), running the tool for 5–

10 seconds and absorbing the oil in a cloth. Protect the tool this way before

longer standstills.

Overhaul and lubrication

The tool should be checked regularly at six-monthly intervals. If it is in heavy

duty service or not running properly, it should be taken out of service more of-

ten for inspection.

Regarding instruction for dismantling and assembly, see separate Service Man-

ual.

The throttle valve, planetary gears, needle bearings and ball bearings must be

lubricated with grease when the tool is dismantled for the regular overhauls.

Molykote BR2 Plus gives long intervals between lubrications.

Clean the motor parts and apply a thin layer of air lubrication oil onto the

vanes and inner surface of cylinder and end plates.

Assemble the motor and check that it is running free. Add two drops of oil

through the air inlet and run the motor (machine) at idling speed for 5-10

seconds.

The strainer in the adapter should be cleaned regularly to prevent choking with

resultant decrease in capacity

Lubricating guide for Grinder/Sander (except turbine) and Drill

Brand

Castrol

Esso

Mobil

Shell

Texaco

Molycote