Valor DIMENSION ELECTRIC Series Manual page 4

Fitting the spacer Frame to the Wall/Surround
Identify the rear of the spacer frame which has two keyhole slots on the top rear flange. Position the rear of the spacer
frame flat against the wall. Ensure that the spacer is central to the fireplace and that the legs are positioned correctly
and are upright. Mark the upper position of the keyhole slots on the wall (Fig 3 ). Remove the spacer frame and drill a
hole on the marked locations using a suitable sized masonry drill bit for the supplied wall plugs. Insert two wall plugs
into the holes, then screw in two wood screws in to the wall plugs until approximately 5-8mm of screw is left protruding
from the wall.
Fitting the Spacer Frame to the Appliance
The spacer frame is secured to the appliance in four positions (Fig. 4). Secure the spacer frame to the appliance using
the four No.8 x 3/8 screws supplied.
Fitting the Appliance with Spacer Frame
Carefully lift the appliance and locate the keyhole slots on the rear of the spacer frame onto the screws in the wall. The
screws can be adjusted to ensure a tighter fit. When mounting to decorative surfaces such as wallpaper, care must be
taken not to drag the appliance down the wall as it may damage the decorative surface.
Fitting the Decorative Fascia to the Appliance (Fig. 5 & Fig. 6)
Fitting the Plastic Infill Trim
Remove the plastic infill trim from its packaging. Locate the four tabs on the rear of the plastic infill trim into the four
corresponding slots on the front of the appliance. Push the infill trim downwards so that the tabs lock in place (Fig. 5)
Fitting the Fascia
Remove the fascia from its packaging. Holding the fascia firmly with both hands, lift it into place. Locate the fascia by
hanging it onto the slots on top of the appliance (Fig. 6) . Lower the fascia into the place and swing the bottom of the
fascia towards the appliance. Secure the fascia in place by the holes in the lower side legs of the fascia using the two
washers and two M4 x 25mm screws supplied.
Fitting the Fret and Ash Pan
Remove the fret and ash pan from their packaging. Centre the fret in front of the appliance. Position the ash pan beneath
the fret.