Epson LQ-1050X User Manual page 231

Problem
The print position is
not what you
expected
(continued).
Skip over perforation is
set, but the perforation
fall
does not in the
of
center the skip.
Troubleshooting
7-14
Solution
The page length for continuous paper
may be set incorrectly. Set DIP switches
2-1 and 2-2 to the correct positions for the
page length you want. See Chapter 3. If
your program allows you to use control
codes, you can also use the ESC C or
ESC C 0 command to set the page length.
See Chapter 9.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position so that the perforation is
centered within the skip area. See
Chapter 3.
Your application program may be setting
the top and bottom margins. If this is the
case, turn off skip over perforation by
setting DIP switch 1-8 to off.