Epson LQ-1050X User Manual page 229

Problem
The print position is
not what you
expected
(continued).
Text is printed with an
extra blank line in
between, even after
setting the auto line
feed setting to off.
Line spacing is
incorrect.
One line of printing
has taken up two lines.
Troubleshooting
7-12
Solution
Your interface cable may not be
configured correctly. Disable the AUTO
FEED XT signal of your interface.
Line spacing is too tight or too far apart.
If your application program is capable of
sending control codes, specify the line
spacing using ESC 0, ESC 2, ESC 3, or
ESC A. See Chapter 9.
Auto line feed may be on. Turn off DIP
switch 2-8.
The margin setting may not be correct.
Use your application program to change
the margin.
In BASIC, enter either of the following
statements:
WIDTH LPRINT 255
WIDTH "LPT1" 255
If the printer still does not print properly,
set the right margin to the maximum
setting using ESC Q. See Chapter 9.