Advertisement
Administration
Power Software allows you to remotely change the password or network security in your Multi-Mon. Use the device base address
to access your device.
To change the password, select a device site from the list box on the Power Software toolbar, check the On-line button, click
Administration from the monitor menu, and then select Change Password.
To change the password, type in a new 8-digit password, repeat the password in the Confirm box, and then click Send.
Upgrading Device Firmware
Your meter has upgradeable firmware. If you need to upgrade your device, you can download a new firmware file to the meter
through Power Software.
Firmware can be downloaded through any communication port. The meter can be connected to your PC through a serial
interface, a dial-up modem, the Internet, or the RF modem.
Upgrading is only supported through the Modbus RTU and Modbus/TCP protocols, so your serial port or a dial-up modem port
should be put into Modbus RTU mode.
Fig. 38.
Fig. 39.
43
MULTI-MON
31-00035—01
Advertisement
