Advertisement
MULTI-MON
To change the port settings, select desired port parameters, and then click Send. For the available communication options, see
Communication Ports in Section 3.
NOTE: When using the ExpertPower client (see Configuring eXpertPower Client), submeter address 99 on the Ethernet
port COM2 is reserved for the Multi-Mon router and must not fall inside the range of the submeter addresses for
this port.
Setting Up the Local Network
To enter the setup dialog, select the device site from the list box on the Power Software toolbar, select Communications Setup
from the Meter Setup menu, and then click the Network Setup tab.
To change the Ethernet settings in your device, select desired parameters, and then click Send. For the available options, see
Local Network Settings in Section 3.
Configuring eXpertPower Client
The Multi-Mon has an embedded eXpertPowerTM client that provides communications with the eXpertPowerTM server – Cloud
AMR services. Connections to the eXpertPowerTM server are handled on a periodic basis.
To enter the Setup dialog, select the site from the list box on the Power Software toolbar, select Communication Setup from the
Meter Setup menu, and then click the ExpertPower Client Setup tab.
31-00035—01
Fig. 25.
28
Advertisement
