Advertisement
MULTI-MON
MENU OPERATIONS
The following table lists available options.
Label
Phase L1
Phase L2
Phase L3
CT
1
The device is pre-configured for twelve three-phase submeters.
2
Specify the CT ratings assuming a ×200% device inputs overrange. The device inputs are preset for 100A current
transformers with a 50A primary rating.
31-00035—01
Submeter Channel Assignments
This menu allows you to link the device current terminals to submeters so they can monitor them.
Additionally, the menu allows you to specify the primary current rating of the current transformers
connected to the device terminals. The number of the selected current inputs for a submeter specifies
if it will be a single-, two-, or three-phase meter.
Always select your submeters in a sequence without gaps so that your device does not occupy
unnecessary network addresses.
To enter the menu, select the SubMeter entry from the main menu, and then press the ENTER button.
To select a parameter you want to view or change:
1. Highlight the upper-right item by using the SELECT button.
2. Select the submeter you wish to configure with the UP/DOWN buttons.
3. Highlight the lower-left item by briefly pressing the SELECT button.
4. Scroll through the parameter list with the UP/DOWN buttons until the desired parameter name
appears.
To change the selected parameter:
1. Highlight the lower-right item by using the SELECT button.
2. To link a current input to a submeter, select the desired input ID with the UP/DOWN buttons.
3. To change the CT primary rating, highlight desired digits by briefly pressing the SELECT button,
then adjust them to the desired value with the UP/DOWN buttons.
4. Press the ENTER button to store your selection. You return to the parameter list to select another
parameter or return to the main menu.
To exit the menu, highlight the menu name (upper-left item) with the SELECT button, and then press
the ENTER button.
Parameter
Phase current input
terminal number
CT primary
2
current
Options
Default
I1–I36,
1
See note
None = not
connected
1-10000 A
50 A
18
Description
Links a current input terminal
to the corresponding
submeter's phase voltage
input V1, V2 or V3
Specifies the primary rating of
the submeter current
transformers
Advertisement
