Eurotech ReliaGATE 10-20 Quick Start page 2

3. Connect the Serial 2 (top DB9 connector) to your PC
serial port using the provided null modem cable (a
terminal emulator will be required in order to
communicate with the ReliaGATE 10-20).
4. Connect the 12 VDC power adapter to the DC power
input, and then connect the power supply. The green
PWR LED illuminates when power is successfully
connected.
5. The system will boot the Linux operating system.
Login at the prompt. The default root login password
is "eurotech".
Hardware Details
USB Host Ports
Two of the three USB 2.0 ports are general-purpose USB
host ports (500 mA max). These are located on the front
next to the serial port connectors. The third is a USB 2.0
port with a USB 3.0 connector used for the interface with
the ReliaCELL 10-20.
eMMC/SD2 Boot Switch (Debug)
Place switch to the left to boot from on-board eMMC.
Place the switch to the right, to boot from an SD Card.
Wi-Fi
By default, ReliaGATE 10-20 boots as a Wi-Fi access point
with an SSID that includes the Eth0 MAC address.
SSID =ReliaGATE 10-20-<eth0_mac>
Passcode = "testKEYS"
110129-00021
Gigabit Ethernet ports
In Linux, the left Ethernet port is assigned to Eth0 and
given a static IP address (
Ethernet is implemented with a high-speed USB 2.0 to
10/100/1000 Ethernet Controller.
Where Do I Find User Documentation?
See the following documents for additional details:
•
ReliaGATE 10-20 User Manual at:
www.eurotech.com/en/products/reliagate+10-20
•
Everyware Cloud Developer's Guide at
http://everywarecloud.eurotech.com/doc/ECDevGuide
•
Everyware Software Framework 3.0 documentation,
as well as router and network settings at
http://esf.eurotech.com/
Eurotech Technical Support
To contact Eurotech Support, go to
http://www.eurotech.com/
Click on Support ->Global Support Center
Eurotech Sales Support
To contact Eurotech Support, go to
http://www.eurotech.com/
Click on About Us ->Contact Us
172.16.0.1
). Note that the right