Cycle For Sending The Control Value (0 = Deactivated) - ABB i-bus VC/S 4 1 Series Product Manual

ABB i-bus® KNX PARAMETERS
7.4.164

Cycle for sending the control value (0 = deactivated)

This parameter is used to define the cycle for sending the control value.
Sending cyclically should not be deactivated to ensure that the actuator receives its control value.
If, in the parameter
cyclically
Option
0 ... 15 ... 60 min
Prerequisites for visibility
• Parameter window
– Parameter
– Parameter
• Parameter window
stage heating
– Parameter
– Parameter
• The parameter is in the parameter window
parameter window
or
• Parameter window
– Parameter
– Parameter
– Parameter
• Parameter window
tional-stage heating
– Parameter
– Parameter
• The parameter is in the parameter window
parameter window
or
• Parameter window
– Parameter
– Parameter
• Parameter window
stage cooling
– Parameter
– Parameter
• The parameter is in the parameter window
parameter window
or
• Parameter window
– Parameter
– Parameter
– Parameter
• Parameter window
tional-stage cooling
– Parameter
– Parameter
• The parameter is in the parameter window
parameter window
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page
Note
Control value difference for sending the control value
is selected, a value > 0 must be selected.
Channel X
Channel function
Basic-stage heating [controller]
Channel X
Type of control value Basic-stage heating
Extended settings
Basic-stage heating
Channel X
Channel function
Basic-stage heating
Additional-stage heating
Channel X
Type of control value Additional-stage heating
Extended settings
Additional-stage heating
Channel X
Channel function
Basic-stage cooling [controller]
Channel X
Type of control value Basic-stage cooling
Extended settings
Basic-stage cooling
Channel X
Channel function
Basic-stage cooling [controller]
Additional-stage cooling
Channel X
Type of control value Additional-stage cooling
Extended settings
Additional-stage cooling
Application parameters
\ Parameter window
\ Option Controller channel
\ all options except Deactivated
Temperature controller
\ Parameter window
Option Yes
\
Channel X \ parameter window
.
Application parameters
\ Parameter window
\ Option Controller channel
\ all options except Deactivated
all options except Deactivated
\
\ Parameter window Temperature controller
\ Option Yes
Channel X \ parameter window
.
Application parameters
\ Parameter window
\ Option Controller channel
all options except Deactivated
\
Temperature controller
\ Parameter window
Option Yes
\
Channel X \ parameter window
.
Application parameters
\ Parameter window
\ Option Controller channel
\ all options except Deactivated
all options except Deactivated
\
\ Parameter window Temperature controller
\ Option Yes
Channel X \ parameter window
.
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B 148
, the option
\ Parameter window
\ all options except PI PWM (On/Off)
Temperature controller
\ Parameter window
all options except PI PWM (On/Off)
\
Temperature controller
\ Parameter window
\ all options except PI PWM (On/Off)
Temperature controller
\ Parameter window
all options except PI PWM (On/Off)
\
Temperature controller
Only send
Basic-
\
Addi-
\
Basic-
\
Addi-
\