Dräger Polaris 600 Supplement To The Instructions For Use page 16

English
 Push at walking speed.
 Reduce the speed even more at thresholds and on uneven
surfaces or ramps.
CAUTION
Risk of collision and tipping
Do not move the light faster than at walking speed.
Reduce the speed even more at thresholds and on uneven
surfaces or ramps.
CAUTION
Risk of personal injury and property damage
If the light runs over electric cables, this can damage the cables.
– Do not run over the power cable or the potential equalization
cable with the castors.
– Check that the power cable and the potential equalization
cable system are free of damage.
Light at the place of use
CAUTION
Risk of personal injury and property damage
Do not lean on the spring arm.
Only move the light using the handle of the tubular stand.
CAUTION
Risk of personal injury and property damage
Do not stand on the trolley.
CAUTION
Risk of personal injury and property damage
Do not lean against the light.
CAUTION
Risk of damage to the device caused by overheating
Do not cover the trolley or parts of it during operation or while
charging the battery.
NOTE
Position the light so that the IR receiver diode is not hidden.
A
16
1 Secure both locking brakes (A) of the trolley.
CAUTION
Risk of personal injury and property damage
The light could move unexpectedly if the locking brakes are not
secured.
Always secure the two locking brakes at the place of use.
2 Connect the power cable (B) to the trolley.
3 Establish potential equalization at the potential equalization
connector (C) using the potential equalization cable.
NOTE
Potential equalization must always be established.
4 Connect the power cable to a grounded mains power socket.
CAUTION
Risk of tripping
If the power cable or potential equalization cable is routed
through foot traffic areas, this can cause falls.
Make sure that the power cable and the potential equalization
cable are laid without posing a risk.
NOTE
Always position the trolley so that the mains plug is freely
accessible.
In an emergency, the light can be completely disconnected from
the mains power supply by pulling the mains plug.
5 Remove the remote control for operating the MedView camera
from the remote control holder.
Supplement to the instructions for use Polaris 600
B
C