Page 2
REDLINE® C 300 cylinder regulators Operating instructions for cylinder pressure regulators. Linde reserves the right to change product specifications or other reasons subsequent to publication. 1. General safety requirements 1.1 General • Do not handle the regulator with a tool but by All users must comply fully with all national or hand only.
Page 3
(except for high pressure oxygen with personal injury. Linde is not responsible for any non-approved use or application.
Page 4
REDLINE® C 300 cylinder regulators High pressure gauge Low pressure gauge Inlet connection Outlet port Hand-wheel Safety valve C300 single stage Low pressure gauge High pressure gauge Outlet port Inlet connection Hand-wheel Safety valve C300 two-stage...
REDLINE® C 300 cylinder regulators 3. Technical data 3.1 Dimensions Ø 50 mm/1.97" 244 mm/9.6" 105 mm/4.14" C300 single stage, weight: 0.9 kg approximately Ø 50 mm/1,97" 244mm/9,6" 180 mm/7.1" C300 two-stage, weight: 1.3 kg approximately...
Page 6
REDLINE® C 300 cylinder regulators 3.2 Safety components Connectable safety valve is an option. Note: This HP pressure regulator must be used with a safety component on the medium pressure system, in order to avoid risks of overpressure. 3.3 Designation of indications (depending on model) Barred oil can (ISO 7000) Do not oil –...
Page 7
Various metals, plastics, adhesives and lubricants are used in these pressure regulators. For further Inlet union ¼" NPT F information, please contact Linde. A sintered filter Outlet union ¼" NPT F is included in the inlet of the pressure regulator.
Page 8
REDLINE® C 300 cylinder regulators 4. Installation instructions and handling 4.1 Transport, storage and handling 4.3 Installation of the pressure regulator • Transport, storage and handling operations • Ensure your hands are clean before installing must be carried out by qualified personnel, or handling the pressure regulator.
Damaged adapters Call Linde Gas issues from the Leak from seat disk holder of pressure Close the cylinder valve – call Linde valve regulator Icing Excessively low operating Close the cylinder valve – bring the...
However, it is recommended to bleed the and all other standards and regulations referred pressure regulator with an inert gas before to therein. start up or after a long period of storage. REDLINE® is a registered trademark of The Linde Group.
6. General conditions 5.3 Checks The information provided in our catalogues is not Whenever a cylinder is changed: binding for Linde, who reserves the right to make • Check that the pressure regulator shows no any modifications. visible signs of damage.
Page 12
Linde AG Linde Gas Headquarters, Seitnerstrasse 70, 82049 Pullach, Germany Phone +49.89.7446-1661, Fax +49.89.7446-1659, hiq@linde-gas.com, http://hiq.linde-gas.com...