Download Print this page

Maintenance - Linde REDLINE C 300 Instruction Manual

Cylinder regulators

Advertisement

10
REDLINE® C 300 cylinder regulators

5. Maintenance

5.1 General
This warranty does not cover the following:
• Repair or replacement due to normal wear or
damage during routine maintenance.
• Damage to components whose fragility is
determined by product design.
• Damage from not following recommended
maintenance and procedures, as outlined in
this instruction manual.
• Damage arising from modifications not
included in the procedures in this instruction
manual.
• Damage resulting from the use of unauthorised
parts, supplied, manufactured or modified by
procedures not included in this instruction
manual.
Maintenance, repairs and/or reconditioning
of these industrial cylinder valves are the
responsibility of the user or the operator and
shall only be performed by properly trained
personnel. Anyone attempting to maintain, repair
or recondition this product must be thoroughly
familiar with compressed gas association E-4,
and all other standards and regulations referred
to therein.
REDLINE® is a registered trademark of The Linde Group.
In the case of an incident or complaint, the user
must return the products that are assumed to
be defective, appropriately packed. In order to
benefit from the warranty, the user must not carry
out any work (disassembly, repair, modification,
etc) on the equipment without prior written
authorisation from Linde.
Failure to follow the installation instructions and
handling instructions may result in accident or
personal injury, for which Linde declines any
responsibility.
5.2 Cleanness
This product must be kept clean. To do so:
• Regularly clean the outside of the pressure
regulator with cotton wool and alcohol (any
other cleaning process is prohibited).
• The lenses of the pressure gauges could show
incompatibility with isopropyl alcohol. For
cleaning, use ethyl alcohol (ethanol).
• The inside of the pressure regulator must
not be cleaned (this is a factory operation).
However, it is recommended to bleed the
pressure regulator with an inert gas before
start up or after a long period of storage.

Advertisement

loading