Air Relief Valve - WAGNER FINISH CONTROL 5500 Operating Manual

EN
MAINTENANCE
13.2

AIR RELIEF VALVE

If paint has entered the ventilation hose, proceed
as follows:
1. Pull the ventilating hose (Fig. 20, 1) at the top from the
gun body. Screw off the valve cover (2). Remove the
diaphragm (3). Clean all the parts carefully.
CAUTION! The ventilation hose and
diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent,
only wipe.
2. Place the diaphragm in the valve cover with the pin facing
forward (Also see the marking on the gun body).
3. Turn the body of the gun upside down and screw on the
valve cover from underneath.
4. Place the ventilating hose on the valve cover and on the
nipple at the gun body.
20
Warning
If the supply cord of this appliance is damaged, it must only
be replaced by a repair shop appointed by the manufacturer,
because special purpose tools are required.
Warning: Do not connect the blue or brown wire to the earth
terminal of the plug! The wires in this mains lead are coloured
in accordance with the following code:
blue = neutral brown = live
As the colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifiying
the terminals in your plug, proceed as follows:
Should the moulded plug have to be replaced, never re-use
the defective plug or attempt to plug it into a different 13 A
socket. This could result in an electric shock.
 Should it be necessary to exchange the fuse in the plug only
use fuses approved by ASTA in accordance with BS 1362. 5 Amp
fuses may be used.
 To ensure that the fuse and fuse carrier are correctly mounted
please observe the provided markings or colour coding in the
plug.
After changing the fuse, always make sure that the fuse carrier
is correctly inserted. Without the fuse carrier, it is not permissible
to use the plug.
 The correct fuses and fuse carriers are available from your
local electrical supplies stockist.
FinishControl 5500