Epson AcuLaser C3800N Series User Manual page 41

EPSON AcuLaser C3800
Transparencies can be loaded into the MP tray only. When using transparencies, you
should make paper settings as shown below:
❏ Make settings on the Basic Settings in the printer driver.
Paper Size:
Paper Source:
Paper Type:
❏ You can also make these settings on the Tray Menu in the control panel. See "Tray
Menu" on page 172.
❏ When the Paper Type setting in the printer driver is set to Transparency, do not load
any other type of paper except transparencies.
Please note the following when handling this media:
❏ Hold each sheet by its edges, as oil from your fingers may transfer to the surface and
damage the printable surface of the sheet. The Epson logo appears on the printable
side.
❏ When loading transparencies in the MP tray, insert the short edge first as shown below.
❏ If transparencies are loaded incorrectly, the message Check Transparency appears on
the LCD panel. To clear the error, see "Transparencies are output blank from the MP
tray" on page 262.
Caution:
c
Sheets that have just been printed on may be hot.
User's Guide
A4 or LT
MP Tray (up to 75 sheets or 15 mm thick stack)
Transparency
41
Paper Handling