Table of Contents
Advertisement
8.2
General information about the web interface
8.2.1
Saving changes
Below each configuration dialog of the web interface, you will find a bar with three buttons:
Fig. 16: Making changes
Save and apply will save the selection and immediately apply it to the device. If you choose Save, the
setting will be saved in the web interface and marked for subsequent use. The configuration page
can be reloaded without changing the set values using the Reset button.
The operating system of the access point saves the configuration changes that are not directly set
via Save and apply for stack processing at a later time. You will see this from the text display Un-
saved changes: in the header of the web interface.
Fig. 17: Header of the web interface: Unsaved changes
If you wish to start the stack processing of the as yet unsaved changes, click Unsaved changes: All
changes that are still outstanding are then displayed and, depending on the category, saved with
the corresponding color according to the key.
Now select either Save and apply to apply the unsaved changes to the device, Reject to reset the out-
standing changes, or Close to exit stack processing without making any changes.
8.2.2
Automatic reloading
Fig. 18: Automatic reloading
On each page of the web interface that has active content, the status Updating or Paused in the
header indicates the current setting of a function.
Fig. 19: Header of the web interface: Updating
Fig. 20: Header of the web interface: Paused
You can change the setting from Updating to Paused and vice versa by clicking the text.
When Updating is displayed, configuration and measured values are continuously read out from the
access point and their changes are displayed immediately on the screen.
Opening the Real-time diagrams menu item in the Status menu displays the real-time values.
If, on the other hand, you want the device values displayed on the screen to remain constant, select
Paused. The values are only updated once the page has been reloaded in the web browser.
8.3
Language setting and design
The factory setting for the web interface language shown is the automatic language selected and so
you will see the web interface in the language of your operating system. Some web browsers, how-
ever, use English as the default language. You can change the language setting under Language and
Wieland Electric GmbH | BA001098 | 12/2022 (Rev. C)
Web interface of the access point
26
Advertisement
Table of Contents
