Table of Contents
Advertisement
5.4
Mounting Recommendations
The mounting instructions provided together with the device should be taken into account during
NOTE
assembly.
The access point is designed to be mounted on a DIN TH 35 – 7.5 mounting rail.
Please take into account the low-voltage directive when mounting the access point in the control
NOTE
cabinet.
5.4.1
Installation position of AP ETH-A and AP 3P ETH-A model version
Position the access point at the start or end of the mounting rail, due to its integrated antenna. Do
not use this model version in metal housings or metal control cabinets.
5.4.2
Installation position of AP ETH-A-A and AP 3P ETH-A-A model version
You can use this model version in metal housings or metal control cabinets. The position on the
mounting rail does not affect the operation of the device. Position the external WLAN antenna out-
side the housing.
5.5
User interfaces (connections)
Table 7: Access point connections
Name
+
–
PE
ETH, P1, P2, P3
ANT *
* applies for AP ETH-A-A and AP 3P ETH-A-A devices
Fig. 3: Front view of AP ETH-
A
Wieland Electric GmbH | BA001098 | 12/2022 (Rev. C)
Connection
Description
Screw terminal
Connection for +24 VDC power supply
Screw terminal
Connection for ground/GND power supply
Screw terminal
Connection for shield grounding
RJ-45
Connection to the LAN network
RP-SMA
Connection for the external WLAN antenna
Fig. 4: Front view of AP ETH-
A-A
Product description
Fig. 5: Front view of
Fig. 6: Front view of
AP 3P ETH-A
AP 3P ETH-A-A
14
Advertisement
Table of Contents
