Related Manuals for Daewoo DWCSS130-220
Summary of Contents for Daewoo DWCSS130-220
- Page 1 CHAINSAW SHARPENER DWCSS130-220 USER'S MANUAL www.daewoopowerproducts.com Manufactured under license of Daewoo International Corporation, Korea...
-
Page 2: Table Of Contents
INDEX 1. SPECIFICATIONS ............................ 2 2. SAFETY WARNINGS ..........................2 3. PARTS LIST ............................. 3 4. ADDITIONAL SAFETY WARNINGS ......................4 5. ASSEMBLY .............................. 4 6. OPERATION ............................. 5 7. MAINTENANCE ............................8 WARRANTY ..............................9... -
Page 3: Specifications
1. SPECIFICATIONS POWER 130-220 W NO LOAD SPEED 3000/7500 rpm WORKING TABLE ADJUSTABLE ANGLE +/- 30° DISC SIZE 100 x 10 x 3.5 mm 2 hex keys, 1 spanner, 1 wrench, INCLUDES 1 M8X80 mm hexc screws, 2 garkets and 2 M8 nuts. 2. -
Page 4: Parts List
18- Never use around flammable materials. 3. PARTS LIST Part N° Descrip�on Part N° Descrip�on Screw Bearing Motor cover Swing arm Power cord Chain stop Top housing Tension spring Switch plate Retaining ring (5) Lock stop Lower knob Grinding wheel base Screw Grinding wheel Bolt... -
Page 5: Additional Safety Warnings
4. ADDITIONAL SAFETY WARNINGS Grinding wheel warnings 1- Do not use a grinding wheel if it is chipped, cracked or worn. 2- Only use grinding wheels that fit the arbor (7/8”). Do not try to change or modify the mounting hole on a grinding wheel to make it fit. -
Page 6: Operation
2. Bolt the unit directly to the workbench through the two ¼” holes on the base. The workbench must have a solid surface capable of supporting the weight of these products, the workplace and assorted tools. See Figure 2. Mounting a grinding wheel. Refer to the assembly drawing on page 10 and Figure 3 and Figure 4 below. - Page 7 Note: raise the top housing while adjusting the chain. 1. Clean the chain before sharpening. Wash it with a non-flammable solvent. Do not use gasoline. Dry the chain. 2. Lift up the chain stop and secure the chain in the sliding guides. See Figure 6. 3.
- Page 8 8. Lock the chain in the sliding guides by tuning the handle. See Figure 8. The handle should be situated so that you can easily release and tighten it. You will need to release it each time you move the next link, and tighten it to sharpen each link. 9.
-
Page 9: Maintenance
1. After sharpening one tooth, turn off the machine. Lift the top housing, release the handle and move the chain so that the next link is positioned in the chain stop. Tighten the handle. Turn the machine back on and continue sharpening the next tooth. Repeat the process. 2. -
Page 10: Warranty
Manufactured under license of Daewoo International Corporation, Korea...
Need help?
Do you have a question about the DWCSS130-220 and is the answer not in the manual?
Questions and answers