Table of Contents
Advertisement
Operation
- Editing Rotor Data
5 - 12
5.2.16 Setup Rotor Data - Measure drive 3 /
Turn Drive
Main menu \ Rotor settings.
Select „Measure Drive 3 / Turn Drive" tab.
Enter values or change settings:.
Runup / Rundown
Speed
Torque Runup
Torque Rundown
Cascade Sequence
This tab is for defining the parameters for Bode plots,
that is for plots covering defined ranges of speed.
Parameters may be set separately for the runup or
the rundown.
For cascades 21-25 the Bode data is displayed only.
The query „Execute bode?" pops up before display.
The Bode plot will not be displayed if this query
is not acknowledged within 10 seconds.
Cascade 26 will pass the data on to the QDA.
MC10 HS
tick either
Set nominal speed in RPM
Set max. torque in Nm
Set max. torque in Nm
Enter no. of next cascade
Advertisement
Table of Contents
