Table of Contents
Advertisement
Basic Operation
- Unbalance Display
4 - 10
Amount and angle
Polar diagram
4.5.1
Displaying Unbalance
Magnitude of unbalance in unbalance and
weight unit
Unbalance location in degrees (°)
Meaning of the different colours and numbers:
Green
Rotor unbalance in tolerance.
Rotor unbalance out of tolerance,
Yellow
correction necessary and possible.
Rotor unbalance exceeds correction limits,
Red
no correction.
INFORMATION
A red indication can have several reasons:
- The unbalance cannot be compensated with the
given possibilities (i.e. drilling diameter and/or max.
drilling depth, material density). The unbalance is
simply too big.
- The initial unbalance exceeds the correction limit
(refer to Chapter 5.2.12 - Setup Rotor Data - Units
and Tolerances).
- The max. number of correction steps has been
reached (refer to Chapter 5.2.13 - Setup Rotor Data -
Correction).
- Repeat measurements are carried out. However,
the MC10 assumes that an unbalance correction is
carried out after each measuring run.
Unbalance magnitude and position
Display of tolerance limit (green ring).
With the corresponding setting (i.e. unbalance
display in components with compensation type
"drilling") you can obtain a direct indication of
the components and/or the compensation val-
ues in a table, instead of the indication of the
amount and angle, simply by touching a polar
diagram on the screen.
You can revert to the standard display by
touching the table.
MC10 HS
Advertisement
Table of Contents
