Eversys Enigma E'2c/Classic User Manual page 12

For Your Safety
IRRITANT PRODUCTS
Everclean and Eversys cleaning ball should be considered potentially dangerous.
When performing any operation on the machine, local safety regulations must be
followed. It is imperative to wear protective gloves and glasses when working with
potentially dangerous materials.
For any other materials referred to in manuals (e.g. Everclean and Eversys cleaning
balls) corresponding safety data sheets should be consulted before the first use,
adequate protective measures should be applied and any applicable regulations
should be followed.
Safety data sheets are available under the e'Support center (https://
support.eversys.com/hc/en-us).
It is imperative to use only the products, accessories, spare parts and software
specified in manuals (e.g. User Manual).
Except for cups, do not place anything on top or above the machine.
The machine is not suitable for installation in an area where a water jet or water
spray might be used.
The machine must not be located on a surface that is sprayed or cleaned with a
water hose, steam jets, steam cleaner, or similar equipment.
The machine must be placed and levelled on a horizontal, water-resistant, heatproof,
and sturdy base capable of bearing its weight, see Technical data (page 31).
For operating, service and safety reasons the machine should be installed with a
clearance of not less than 50 mm at the back and sides from the building or non-
approved equipment. A minimum working space of 650 mm in front the coffee
machine and overhead clearance of at least 250 mm above the bean hoppers
are recommended. A clear height of 1000 mm for E'line, Enigma, Shotmaster and
accessories, 950 mm for Cameo machines and accessories (with high feet) and 900
mm for Légacy, Cameo machines and accessories (with standard feet) from the top
of the installation surface should be ensured. The height of the installation surface
above the floor is at least 800 mm. If the coffee machine connections are to be run
downwards through the counter, please make space for the lines, which can reduce
the usable space below the coffee machine.
The machine is only to be installed in locations where its use and maintenance is
restricted to trained personnel. Please refer to "Persons" (page 155).
Only connect the machine to the mains in accordance with the information on the
rating plate, see Rating plate of Enigma | Shotmaster machines (page 23).
Adjustment of the frequency is automatic. No action is required.
The power cord must be in accordance with local regulations.
Voltage/current specifications are as listed in the table Electrical data and power
overview of Enigma machines (page 41).
Voltage/current specifications are as listed in the table Electrical data and power
overview of Shotmaster machines (page 43).
© Eversys S.A. Page 12 of 172 02.01.2023