Installing The Duplex Unit - Oki B6200 Series User Manual

INSTALLING THE DUPLEX UNIT

You can install a duplex unit option on this printer. If a face up tray has
been fitted, remove it by reversing the steps in
(Rear) Tray" on page 14
when the duplex unit has been installed.
1. Remove the duplex unit cover by pushing the two tabs as
shown in the diagram (1).
Next, remove the connector cap at the top right of the back of
the printer (2).
2. Insert the right and left tabs at the bottom of the duplex unit
into the holes at the back of the printer, and then align the top
part of the duplex unit with the printer.
Ensure that the connector of the duplex unit is connected to
the connector of the printer.
INSTALLATION AND RELOCATION PROCEDURE > 21
before installing the duplex unit and refit it
"Installing the Face Up