Toro POWER MAX HD Service Manual page 84

Wheel Clutch Reassembly (continued)
Wheel Clutch Traction Drive System: Service and Repairs
3. Clamp or hold the gear and turn it over to properly install the 3 pawl supports
and torx screws.
4. Torque the T-27 torx screws to 100–125 in-lbs. (11.3–14.1 Nm).
5. Install the 4 guide collars to the shaft with the shift brace plate.
6. Torque the screws to 50–70 in-lbs. (5.65–7.9 Nm).
7. Slide the flat washers into position next to the guides.
8. Install the RIGHT and LEFT collar into position.
Note: The top flanges of the shift collars have "left" and "right" stamped
into them. Install accordingly on the right and left ends of the shaft with the
shift brace plate oriented as shown.
9. Install the compression springs under the pawls.
10. Slide the thrust washer onto the 32–tooth sprocket.
Figure 75
Figure 76
Page 9–18 POWER MAX® HD Service Manual
3424-820 Rev A