Advertisement
Traction Drive System Removal (Autoturn Models) (continued)
Traction Drive System Installation (Autoturn Models)
Wheel Clutch Traction Drive System: Service and Repairs
12. Remove the stub shaft, transmission, and axle from the machine.
1. Install the axle, transmission, and stub shaft onto the machine.
2. Place the axle into position on the housing.
3. Slide the axle bearing into position.
4. Install the snap ring securing the axle bearing to the housing.
5. Install the hex shaft and friction wheels.
6. Install both bearing retainers. Install the 2 screws securing the bearing
retainers and hex shaft to each side of the traction assembly.
7. Install the 4 screws (2 per side) securing the intermediate shaft to the housing.
8. Install both wheel keys and wheels.
Figure 67
Figure 68
Page 9–14
POWER MAX® HD Service Manual
3424-820 Rev A
Hide quick links:
Advertisement
Chapters
