Toro POWER MAX HD Service Manual page 44

Deflector Cable Removal (continued)
Deflector Cable Installation
Deflector Cable Adjustment
Controls: Service and Repairs
4. Remove the cable clamp on the traction housing.
1. Connect the cable end to the deflector. Secure with a cable clamp.
2. Connect the Z-bend end to the machine.
3. Install the cable onto the bracket. Secure with tabs.
4. Connect the cable clamp to the traction housing.
Make sure the Quick Stick is in the maximum rear position and centered; ensure
the deflector is in the full upward position. Draw the slack out of the cable and
secure the clamp.
Figure 26
Figure 27
Page 5–14 POWER MAX® HD Service Manual
3424-820 Rev A