Infineon PSoC 62S2 Wi-Fi Bluetooth prototyping kit Quick Start Manual

Quick start guide
PSoC 62S2 Wi-Fi Bluetooth® prototyping kit
TM
CY8CPROTO-062S2-43439
Low-cost hardware platform that enables design and debug of PSoC™ 6 MCUs
1. Before you start, ensure that you have the following:
• PC with USB port and Wi-Fi connectivity
• UART terminal software such as Tera Term or Minicom
• Non-enterprise Wi-Fi network with internet access or a mobile hotspot
2. Download and install the required software from the
3. Ensure that jumper J3 is at position 2–3 to select 3.3 V.
4. Connect the KitProg3 USB connector (J8) to your PC.
5. Wait for the driver installation to complete.
6. Open the UART terminal software and connect to the KitProg3 USB-UART
COM port with the following settings:
Baud rate: 115200, Data: 8 bit, Parity: None, Stop bit: 1 bit, Flow control: None.
7. Press the RESET switch (SW1) on the kit.
8. Follow the instructions displayed on the UART terminal to use the
pre-programmed code example. Refer to the kit guide available at the kit webpage for details.
For more information, please visit:
Published by Infineon Technologies AG
81726 Munich, Germany
kit webpage
www.infineon.com/CY8CPROTO-062S2-43439
© 2023 Infineon Technologies AG.
All Rights Reserved.
Document Number: 002-36468 REV. **
Date: 02/2023
KitProg3 USB connector (J8)
Power selection
RESET switch (SW1)
jumper (J3)