Power Cord Requirements For Ac-Powered Switches And Ac Power Supplies - Extreme Networks 9920 Installation Manual

Power Cord Requirements for AC-Powered Switches
and AC Power Supplies
Physical specifications
Depth:
Weight:
Electrical specifications
Thermal rating:
MTBF rating:
Connector type:
Power dissipated

Power Cord Requirements for AC-Powered Switches and AC Power Supplies

An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
•
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
minimum wire size is 16 AWG (1.0 mm
The power cords for switches that use either the 1100 W or 715 W power supplies are keyed with a
"notch" to ensure the proper orientation when plugged in. These cords are of 3x14 AWG.
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/.
64 9920 Network Packet Broker Hardware Installation Guide
10.98 inches (27.9 cm)
4.4 pounds (2.0 kg)
Maximum
Typical
2
).
Technical Specifications
443.56 BTU/hour
370,228 hours @ 25°C
SFP+
130 watts
70 watts
2
) minimum; over 6 feet, the
http://