Table of Contents
Advertisement
Operation
1. Press the ON/OFF button to control the start up or shut down of the unit. When using
this button to shit down the unit, please note that the fan will keep running for another
3 minutes, in order for the unit to blow dry itself and prevent mold from forming.
2. The INCREASE and DECREASE buttons are used to select your desired indoor humidity
level or set the time on timer mode. These buttons will increase or decrease the humidity
or time in increments of 1.
3. Press the MODE button to select between the 4 modes.
• DRY Mode - Press the mode button until the 'DRY' indicator light is on. Press the INCREASE
or DECREASE buttons to choose your desired humidity level. The adjustable range is
35%RH-80%RH. The screen will display the set humidity, and after two seconds, display
the ambient humidity. When the ambient humidity is lower than the set humidity, the
compressor will stop running and after a few minutes, the fan will also stop running. On
this mode, the fan speed is set on low and cannot be adjusted.
• TURBO Mode - Press the mode button until the 'TURBO' indicator light is on. Press the
INCREASE or DECREASE buttons to choose your desired humidity level. The setting
humidity is 35%RH. The screen will display the set humidity, and after 2 seconds, show
the ambient humidity. On this mode, the fan speed is set to high and cannot be adjusted.
• COMFORT Mode - Press the mode button until the 'COMFORT' indicator light is on.
On this mode, the appliance will automatically begin setting the humidity according
to the ambient temperature. The humidity cannot be adjusted manually. The ambient
temperature will show on the display, and the fan speed is set to low and cannot be
adjusted. Whilst this mode is in function, the screen lights will go dim, and then turn
off after 1 minute. If you want to check the status of the device, press any other button
for the screen to light up again. After 1 minute, if left on this mode, the lights will turn
off again.
• CONTINUOUS Mode - Press the mode button until the 'CONT' indicator light is on. On this
mode, the setting humidity is 15%RH and cannot be adjusted. The unit will continuously
run, and the fan speed is set to low and cannot be adjusted.
4. Press the TIMER button to delay the unit to start up or shut down. This helps to avoid
wasting electricity by optimising operating periods.
• PROGRAM START UP - Press the TIMER button, and the screen will begin to flash.
Press the INCREASE or DECREASE buttons to adjust the time from 0.5-24 hours. After
5 seconds, the timer will start and the 'TIMER' indicator light will turn on. The display
will count down the time remaining until the unit will start up. When the appliance turns
on, it will work in default state. The humidity will be set to 50%RH and the fan speed
will be low. Press the TIMER button again to cancel this function.
• PROGRAM SHUT DOWN - When the appliance is running, press the TIMER button
and the screen will begin to flash. Press the INCREASE or DECREASE button to adjust
the set time from 0.5-24 hours. After 5 seconds, the timer will start, and the 'TIMER'
indicator light will turn on. The unit will run until the timer is finished. Press the TIMER
button again to cancel the function.
16
Advertisement
Table of Contents
