Operation - Dimplex DC25DEHUM Instruction Manual

Operation

1. Press the ON/OFF button to control the start up or shut down of the unit.
2. Press the MODE button to choose between DRY, TURBO, COMFORT or CONTINUOUS
mode.
• DRY Mode - Press the MODE button until the DRY indicator light is on. Press the INCREASE
or DECREASE buttons to select the desired humidity. The adjustable range is 35%RH to
80%RH. On this mode, the fan speed is set to LOW and cannot be manually adjusted.
• TURBO Mode - Press the MODE button until the TURBO indicator light is on. The setting
humidity is 35%RH. Press the INCREASE or DECREASE buttons to set the desired
humidity. The display screen will show the set humidity, and after 2 seconds will change
to display the ambient humidity. On this mode, the fan speed is set to HIGH and cannot
be manually adjusted.
• COMFORT Mode - Press the MODE button until the COMFORT indicator light is on.
In this mode, the unit will automatically set the humidity according to the ambient
temperature. The humidity cannot be manually adjusted, and the fan speed is set to
LOW and also cannot be manually adjusted. In this mode, the display screen will firstly
go dim, and then turn off after one minute. To check the status, press any button on
the control panel and the screen will light up again for one minute. Press the MODE or
ON/OFF button to exit this mode.
• CONTINUOUS Mode - Press the MODE button until the CONT indicator light is on. On
this mode, the set humidity is 15%RH and cannot be manually adjusted. The fan speed
is set to low and also cannot be manually adjusted. The unit will continuoulsy run until
CONTINUOUS mode is switched off.
3. Press the INCREASE or DECREASE buttons to either set the desired humidity level
or to set the timer function to your desired time. Please note, the humidity adjustable
range is 35%RH-80%RH. The display screen will show the set humidity, and after a few
seconds turn to the ambient humidity. When the ambient humidity is lower than the set
humidity, the compressor will stop running and after a few minutes, the fan will also stop.
4. Press the TIMER button to set the timer on the device between 0.5-24 hours. You can
set the timer for PROGRAM START UP or PROGRAM SHUT DOWN.
• PROGRAM START UP - Turn the device on and choose your desired mode. For example,
dry mode at 65%RH, then turn off the appliance. Press the TIMER button, and the
display screen will begin to flash. Once the screen is flashing, press the INCREASE or
DECREASE buttons to set your desired time between 0.5-24 hours. 5 seconds post
setting your time, the timer function will begin and the TIMER indicator light will switch
on. The control will count down the time remaining until start up. To cancel, press the
TIMER button agaain and the indicator light will switch off.
16